Issues with this web site should be reported to support@haywoodmachine.com
There are currently 2 sizes of Boiler Tube Alignment Clamps available for rent.
•Small ( A model ) - 7/8" through 1-3/4" OD Tubes
•Large ( B model ) - 1-3/4" through 2-1/2" OD Tubes
•Large ( D model ) - 2-1/2" through 3" OD Tubes
These clamps are supplied with Custom made, Heat Treated Alloy U-bolts.
When ordering please specify OD of tubing and width of membrane if Clamps are to be used on waterwall tubes.
•2 ea. - U-bolts with extra flange nuts are supplied with each clamp at no extra cost.
•Order as many U-bolts as you think will be needed for the job, there is no charge for U-bolts that are returned in unused condition.
•Ratchet Wrenches or ½” drive deep well sockets ( 11/16” ) can be supplied if requested.
There are currently 2 sizes of Panel Jacks available for rent.
•The small one is preferred for about 90% of all tube panel membrane fit up, and is designed for use with an ( Enerpac RC-102 or OTC C-102C ) cylinder. (Cylinders are not supplied )
•The large one is preferred where membrane fit up needs a longer jack as on some Supercritical Boilers and is used with an ( Enerpac RC-104 or OTC C-104C ) cylinder.
They both have the same amount of jacking force and have been tested at the full capacity of the Porta Power cylinder ( 10 Tons ).
* When ordering weld on lugs for the Panel Jacks, please specify whether the jacks will be used for plates/beams or waterwall tubes, the OD of the tubing & membrane width is needed for the proper lug length. These 2 or 4 hole lugs can be reused many times.
Shipping Information
All orders will be shipped UPS ground service unless another form of shipment is requested. There will be a prepaid return shipping label in the container along with a list of equip. that was shipped in that container. You will be billed for the actual shipping charges on your final invoice
To return the equipment, simply attach the prepaid label to the container and call 1-800-742-5877 for a UPS pick up at your location.
Links